1x Pair of Lily of the Valley Polymer Clay stainless steel hardware earrings
This item is made to order. If you see stock quantity level, it means it will be despatched next business day, otherwise it will be made and despatched within 1 week from date of order.
This pair of earrings features very dainty, small lily of the valley flowers in a 3D connected chain design.
Each pair is made by hand and there may be differences with each lily of the valley bud. To make the lily of the valley flowers, each petal is moulded by hand, and then each flower goes through a demoulding process before it is assembled with the crystals and beads.
Each lily of the valley has a light green genuine Swarovski crystal inside (a bit like the reverse of a lily of a valley flower colour scheme) and capped with a Miyuki Delica glass bead in gold. This pair was mounted on a 4mm ball stud and 2.5mm chain.
This design is designed to be simple yet complex, and all the components are kept as small as possible.
To wear: simply put on the backing as usual (try to keep the side of the backing with the chain facing on the bottom so your chain falls straight), and the earring will sit. There will be a chain loop under the lobe with two lily of the valley flowers, plus an additional chain that hangs from behind your ear lobe with a single lily of the valley on the end.
This earring was designed to not only be seen from the front, but also from the sides for extra dimension.
Made from polymer clay and hours of design and patience.
Note: Please check measurements below as the model is not to scale - it was used to demonstrate how the earring looks when worn.
Each lily of the valley flower is on average 9mm in diameter
-Please supervise children if you choose to let them wear these earrings
-Please do not submerge in water and avoid wetting/ moisture
-These were made from polymer clay, so please do not squeeze/ crush, drop or leave hanging around (eg. in a handbag) to ensure it stays in its original condition
-All items were handmade, so please allow for differences in the measurements. Slight imperfections are normal such as fingerprints; each piece has been QC'd prior to sending out.
-Stainless steel generally does not change colour, but under some circumstances such as chemistry with certain skin types, lots of friction, or prolonged exposure to chemicals and alcohols (eg. perfumes) may cause the steel to discolour, but this is rare (think of wear and tear of your standard steel watch band).
-Due to computer screens and photography, the colours may have slight differences to the actual product.
HANDMADE IN SYDNEY, AUSTRALIA